How do you reset a talking watch?

  April 30, 2021
      No Comments

How do you reset a talking watch?

Re-calibrate the shifted second-hand:

  1. Make sure the watch is running normally.
  2. Hold 8 o’clock button for more than 5 seconds until the watch says “Set alarm, Press 10 o’clock button to set.”
  3. Push 8 o’clock button 5 more times until the watch says “Second-Hand Alignment, Press 10 o’clock to set.”

How do you set a Reizen atomic watch?

Set the time

  1. Press and hold S4 until you hear “Set Alarm”
  2. Then press S4 again and again until you hear “Set Time”
  3. Press S3 to set, this is, to selection this function.
  4. Press S1 to set the hour. Press repeatedly to advance one hour each time.
  5. Press S2 to set the minute.
  6. Press S4 to confirm the time selected.

How do you set a Reizen Talking Clock?

Setting the Time/Date: Go into Time mode (Note: if you are in Alarm mode, press MODE button once.) Press and hold down the SET button for 3 seconds. You will hear a beep and hour will flash. Use UP/DOWN KEYS to set hour.

How do you set a 2 button talking watch?

Press the Si button (2 o’clock button) repeatedly until the watch speaks the correct hour. . Press the S2 button (4 o’clock button) to set the hour. . Once the hour is confirmed, the watch will instruct you to hit the Si (2 o’clock button) to set the correct minute. .

How do I reset my Reizen clock?

Press the “Reset” button and replace the cover. Open the battery cover on the back of the main unit and insert two AA batteries. Press the “Reset” button and replace the cover. Press the “Mode” button on the front of the main unit three times to ensure that the sensor and main unit are synced.

How many batteries are in a talking watch?

Your new Talking Watch uses a real voice that automatically synchronizes to the analog watch face. The watch contains only one battery and one quartz crystal inside in order to maintain the timekeeping for both the voice and the watch hands.

How do you set a two button talking watch?

1. Holding S2 (4 o’clock button) while the watch is in the real time mode for more than 5 seconds until the watch speaks “Set Alarm, Press 2 o’clock button to set” 2. Press S2 (4 o’clock button) once again and the watch says “Alarm ON/OFF, press 2 o’clock button to set” 3.