How do I setup my Linksys lrt224?

How to configure an EasyLink VPN Tunnel for Site-to-Site VPN

1. Access the web-based setup page of Router 1 and Router 2.
2. Under the Configuration tab, click Setup > Network.
3. In the WAN SETTING section, click the WAN1’s Edit button.
4. Select Static IP for the WAN Connection Type.
5. For Router 1, enter “10.0.

How do I reset my Linksys lrt224?

To do this, press and hold the RESET button located at the back of the router for over 20 seconds using the tip of a pencil or a paper clip. The router will restore its configuration to factory defaults and restart itself.

How do I connect to my EasyLink VPN?

What is EasyLink VPN?

What is EasyLink VPN? EasyLink VPN replaces the conventional complicated VPN setup process by entering Server IP, User Name, and Password. An LRT router can be an EasyLink VPN Server and an EasyLink VPN Client. As a Server, the LRT router can accept (inbound) connections from up to five (5) Clients.

Does Dual-WAN increase speed?

Bittorrent. By design, the bittorrent protocol uses multiple internet connections to download (and upload) files. A properly configured dual WAN router could significantly improve bittorrent performance by spreading the load over both internet connections.

What is EasyLink WIFI?

EasyLink is a pre-configured point to point (PtP) Bridge kit which allows for connecting remote locations wirelessly up to 2 miles away. Connect locations by mounting the hardware, powering the units and aligning them using the built-in alignment LEDs.

How do I access my router WAN IP address?

To access the Router, you should enter your Router’s WAN IP address into your browser’s address (in IE) or location (in Netscape) box and the custom port number. For example, if your Router’s WAN address is 202.96. 12.8 and you use port number 8080, enter http://202.96.12.8:8080 in your browser.

How to configure the DMZ port on the lrt224?

NOTE: It is recommended to designate the configurable port on the LRT224 as a DMZ port . Go to Device Configuration > Network and check the Enable DMZ box . IP Address: IP address of DMZ port .

How do I set up SMTP on a Linksys router?

If there are two routers under the device, users should input “2” for the router layer. The default is “1. ” (Max. is 15.) Interface: Select WAN port or LAN port for network connection location. Linksys Setup SMTP Port: 1~65535 can be accepted. The default value is 25.

How to configure Linksys router configuration?

Linksys Getting Started with the Router Configuration Configuration Type: 10Base-T / 100 Base-TX / 1000 Base-TX. You may click Setup Wizard button to launch wizard. Interface: LAN/WAN/DMZ. Link Status: Up or down. Port Activity: Port Enabled, Port Disabled, or Port Port Statistics Connected. Indicates whether Email Log is activated .

How can I contact Linksys customer support?

Chat with a customer support agent directly from your desktop. I have a question about a Linksys product or a Linksys Store promotion. Get help with an issue or learn how to maximise the potential of my Linksys product.