How do you control RCS in KSP?

How do you control RCS in KSP?

The Reaction Control System, or RCS, is a set of monopropellant-fuelled (with the exception of the Vernor Engine) thrusters primarily intended for vessel orientation in a vacuum. It is toggled on and off by pressing the R key (default key binding).

How do I use MechJeb maneuver planner?

After you have a stable orbit, close Ascent Guidance and open the Maneuver Planner from the MechJeb menu. Go to the map view, and set the Mun as your target. In the Maneuver Planner use the arrows to select ‘Hohmann transfer to target’. Then, click ‘Create and execute’.

What can MechJeb do?

Ascension. This automates launching a rocket into orbit and is great for reducing the tedium of launching that 100000’th rocket.

  • Maneuver Node Planner. This automates creating and executing manuever nodes.
  • Landing. I use this to do the final landing after manually doing the initial descent.
  • How do you use MechJeb 2 in KSP?

    DStaal

    1. Launch to orbit.
    2. Once circularized, set the space station as the target.
    3. Open MechJeb Maneuver Planner, select ‘Bi-Impulsive Transfer to Target’.
    4. Plot and execute burn.
    5. In MechJeb Maneuver Planner select ‘Fine-Tune Closest Approach to Target’.
    6. Plot and execute burn.

    What is RCS in KSP?

    From Kerbal Space Program Wiki. The Reaction Control System, or RCS, is a set of monopropellant-fuelled (with the exception of the Vernor Engine) thrusters primarily intended for vessel orientation in a vacuum. It is toggled on and off by pressing the R key (default key binding).

    How do I use SAS in KSP?

    The system can be toggled with (by default) the T key and temporarily switched by holding down the F key (for example, if SAS is on, holding F will turn it off, and releasing F will turn it back on). The current state of the SAS system is shown by a blue light on the navball.

    Where does MechJeb install to?

    Locate the KSP folder and click on GameData. You should see a “Squad” folder if you haven’t modded your KSP version yet. Now drag your ‘MechJeb2’ folder into the game folder and tada! You have now successfully installed an addon.

    How do I use MechJeb2 KSP?

    You use launch to target.

    1. Once on the pad switch to map view and select the station as your target.
    2. Set your orbit altitude the same as the station.
    3. Make sure your phase angle is zero and auto warp is on to deal with the wait time.
    4. Launch.
    5. After the circularization burn is done, revert to launch.