What is the maximum number of alarm panels The LNL 3300 will support?
The NGP-3300 Series can support up to 500,000 cardholders, 1024 Standard or Intrusion Type Input Points, 256 Outputs, and 130 Doors (Entry/Exit Readers per Door).
How do you program a lenel 2220?
Here are the steps to perform this:
- Configure the computer IP address in the range of 192.168.
- Connect the LNL-2220 to the computer using a crossover cable or hub.
- Turn DIP switch 1 OFF, 2 ON, 3 OFF, and 4 OFF.
- Cycle power to the LNL-2220.
- Wait approximately 30 seconds for the panel to reboot.
What is a Lenel panel?
Overview. Lenel has two series of controller offerings for the OnGuard® Platform. Each series has unique capabilities, but consists of similar components: one or more Intelligent System Controllers as well as specific Reader Interface Modules, Input Modules, and Output Modules.
How many auxiliary inputs and outputs does the LNL 1100 support?
The Input Control Module contains two (2) form-C dry-contact relay outputs, Aux Out 1 and Aux Out 2, which each provide up to 5A 30 VDC, or 125 VAC current (resistive) relay. To wire the Aux Out 1 and Aux Out 2 outputs, use sufficiently large wires for the load to avoid voltage loss.
What is dual reader interface module?
Overview. The RSC-2 is a two-reader interface module designed to connect a wide range of security devices in access control solutions. The RSC-2 supports interfacing 2 card readers, 8 monitor points and 6 relay outputs to any Open Options intelligent controller.
How many auxiliary inputs and outputs does the LNL 1200 support?
The DRI includes eight inputs that support normally open, normally closed, supervised, and non-supervised circuits. In addition, six output relays support fail-safe or fail-secure operation. Output Control Module Up to 16 Outputs per LNL-1200 RS-485 Multi-drop up to 4000 ft.
What is the maximum number of access levels that can be configured in onguard?
The timezone list can include up to 255 different time- zones.
What is a Lenel controller?
The LNL-2220 Intelligent Dual Reader Controller (IDRC) by Lenel provides a single board solution for interfacing one or two doors to an OnGuard® system. The downstream RS-485 two-wire port can be used to connect up to 32 devices (maximum 64 doors).
What is the maximum number of access levels that can be configured in OnGuard?
What is the maximum number of access control card formats that can be downloaded to a reader interface module?
Each DRI supports up to eight different card formats as well as issue codes for both magnetic and Wiegand card formats. The DRI provides a vital link between the Intelligent System Controller (ISC) and the card reader attached to the interface.
What is the purpose of OnGuard list builder?
OnGuard is a library of components, classes, and routines that allow you to protect your applications after they are released to the public.
What does OnGuard software do?
The OnGuard system can bi-directionally exchange cardholder data with many HR platforms and/or ERP systems, coordinate alarm/event data with emergency response systems, and provide/receive event information with various building management, network management and third-party security systems.